Re: Software Raid redux

[Bernd Walter <ticso_(_at_)_cicely12_(_dot_)_cicely_(_dot_)_de>]

On Fri, Mar 10, 2006 at 04:20:55PM +0100, Joacim Melin wrote:
> FreeBSD gives the same output even if I point the root partition to / 
> dev/ad0 in fstab but leave geom_mirror_load="YES" in /boot/ 
> loader.conf.  Only when I remove geom_mirror_load="YES" and point the  
> root partition correctly in /etc/fstab will it boot properly again,  
> but then it of course won't utilize the raid.

Sounds both drive have a gm0 gmirror-label and the build gm0 was done
from the wrong drive.
Go into single user mode and wipe out the config on the new drive.

-- 
B.Walter                http://www.bwct.de      http://www.fizon.de
bernd_(_at_)_bwct_(_dot_)_de           info_(_at_)_bwct_(_dot_)_de            support_(_at_)_fizon_(_dot_)_de
_______________________________________________
freebsd-sparc64_(_at_)_freebsd_(_dot_)_org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-sparc64
To unsubscribe, send any mail to "freebsd-sparc64-unsubscribe_(_at_)_freebsd_(_dot_)_org"